REMOVING AND INSTALLING PANELS

Panel shown slightly rotated to allow top tab to exit (or enter) top slot for removing (or installing) panel.

WARNING

LOUVERED PANEL REMOVAL

Remove the louvered panels as follows:

1.Remove two screws, allowing the panel to swing open slightly.

2.Hold the panel firmly throughout this procedure Rotate bottom corner of panel away from hinged corner post until lower three tabs clear the slots as illustrated in detail B.

3.Move panel down until lip of upper tab clears the top slot in corner post as illustrated in detail A.

REMOVE 4 SCREWS TO

REMOVE PANEL FOR

ACCESSING COMPRESSOR

AND CONTROLS.

Position panel with holes aligned; install screws and tighten.

LOUVERED PANEL INSTALLATION

Position the panel almost parallel with the unit as illustrated in detail D with the screw side as close to the unit as possible. Then, in a continuous motion:

1.Slightly rotate and guide the lip of top tab inward as illustrated in detail A and C; then upward into the top slot of the hinge corner post.

2.Rotate panel to vertical to fully engage all tabs.

3.Holding the panel’s hinged side firmly in place, close the right−hand side of the panel, aligning the screw holes.

4.When panel is correctly positioned and aligned, insert the screws and tighten.

Detail C

Maintain minimum panel angle (as close to parallel with the unit as possible) while installing panel.

Detail D

Detail A

LIP

SCREW

HOLES

Detail B

ANGLE MAY BE TOO EXTREME

 

HOLD DOOR FIRMLY ALONG

 

 

THE HINGED SIDE TO MAINTAIN

 

 

FULLY−ENGAGED TABS

 

 

ROTATE IN THIS DIRECTION; THEN

DOWN TO REMOVE PANEL

PREFERRED ANGLE FOR INSTALLATION

Figure 7. Removing and Installing Panels

Page 10

506586−01 10/10

Page 10
Image 10
Lennox International Inc 506586-01 Louvered Panel Removal, Louvered Panel Installation, Detail C, Detail D Detail a