No Digital Audio Output, No Effects Output | Lexicon PCM 80 manual

PCM 80 User Guide

Lexicon

Operational Problems

Power On Behavior

The PCM 80 will not lock onto an incoming digital signal.

Check the cables that you are using. DO NOT USE ANALOG AUDIO CABLE TO CONNECT DIGITAL AUDIO.

Also check to make sure that your input signal complies with S/PDIF format standards. The PCM 80 will recognize AES professional format signals from an appropriate connector, but will not necessarily read and transmit encoded information accurately.

No Digital Audio Output

Check the Analog Lvl and Digital Lvl controls at Control mode 0.1 and 0.2.

No Effects Output

Check the setting of Mix Mode at Control mode 1.1. Also verify that any controllers patched to FX Lvl, Input Level, or Mix are not turned off.

The PCM 80 performs a series of self tests each time it is powered on, then displays the PCM 80 copyright notice. This should be followed by the display and loading of the last loaded effect. If this sequence does not occur, contact Lexicon Customer Service.

6-2

Image 130

Lexicon PCM 80 manual No Digital Audio Output, No Effects Output

Contents

PCM Precautions Unpacking and Inspection PCM Vigtig information om sikkerhed Wichtige Sicherheitsanweisungen Contents Contents, contd . The Algorithms and their Parameters Presets Contents, contd Introduction Editing Expansion User Interface Block Diagram Program Banks HeadroomUp/Down Load Balanced Outputs AC PowerFootswitch Input Level Mono Applications Footswitch/Foot ControllerAnalog Audio Digital Audio Unbalanced Balanced Headroom DisplayOverload Setting Analog and Digital Input Level Setting Output Level Press Control ConfigurationsConnection to a mixing consoles effects sends Global Pcmcia Sram Memory Card 68 pin, Type Memory CardsPin Simm Memory Module Basic Operation Xxxxxxx Bypass currently selected Row Audio Word Clock Audio Word Clock Ext Prf 44.1kHz Cns 48kHz Error Log Dig In Status Analog In Lvl Dig In Lvl Auto Lock Scms Emphasis Bit Mix ModeOutput Level Bypass Mode/Bypass Src Tempo ModePgm Bypass Auto Load Patch UpdateMem Protect Initialize Row Card Bank Copy Receive ResetFormat Transmit Map OffChain Int Clock Send Foot Pedal, Foot Sw 1, Foot Sw 2, AdjustAutomation SysEx Default Setting Row Setup StoreControl Mode Matrix Location Tempo Mode Matrix Location Pgm Assign Row Mapx Map 0 and MapRow Chain Map Program and Register Banks Chorus+Rvb Register Tempo Mode BeatValue Row Tempo RateSource Tap Source and Tap Level Row Tap Tap DurationAverage Prime Blue Soft Row Compare is on Stored effect active Protection Off Turning MemoryTempo Rate and BeatValue Tap Duration and Average Renaming the Adjust Knob Patch Register Location Concert Hall Plate Band+Rvb Mod Sw Entering Soft Row Assign About Sources Patch Sources Internal Env L Release Env R Rate, P Width, Mode Attack, Release, ModeRate, Shape, P Width, Depth Assigning Values Jump Jump contd Default valuesPatching Examples Creating a patch with Patch 1 Dst Unassigned Adjusting the modulation Source parameters Changing the default destination values Adding an additional pivot point to the patch Patch Values 000 Multiple Patches with the Same Destination Algorithms and Their Parameters 4-Voice Algorithms Reverb Shell Algorithms and Their Parameters PCM 80 User Guide Lexicon Algorithms and Their Parameters PCM 80 User Guide Lexicon Algorithms and Their Parameters 6-Voice Algorithms Algorithms and Their Parameters PCM 80 User Guide Lexicon Chorus+Rvb contd PCM 80 User Guide Lexicon Band+Rvb contd Resonant Chord Algorithms Res1Plate Res2Plate Resonant Chord Algorithms Res1Plate Res2Plate contd MstDepth and MstRate Voices Depth and Rate InLvl L&R, InPan L&R FX AdjustMix High Cut Controls contd. FX Width Value Display Label Description GldResp Master, GldResp, GldRange, ClearClear Master GldRange Expanded Delay Time Delay Time contdAlgorithm Delay Time Voices Mstr Fbk, Mstr X-Fbk Voices 1-6 Fbk, X-Fbk Gld Lvl Mstr LC/HCV1-V6 LoCut and HiCut Left a Lvl L and a Dly L Fbk L/R Glide FX contd Mod LFO Mod AR Env Modulation contd Mod Env L and Mod Env R Modulation contd. Mod Latch Width Mod Sw 1 and Mod Sw Modulation contdMode, T Lvl and T Src Rate Mode Panning Values DstPCM 80 Patch Sources Assign TuningRes 1Plate Pitch parameters Active Res 2Plate Pitch parameters Pitch contd V1-V6 Pitch Algorithms and Their Parameters Size Mstr Res,Mstr HCV1Res,V1 HiCut-V6 Res,V6 HiCut Duration Depth Shape, Spread Rvb Design contdDef Spin Low Slope and Mid Slope Pre DelayMid Rt and Low Rt Crossover PstMix, PstGld RefLvl L&R, RefDly L&REkoFbk L&R,EkoDly L&R Pst Mix PCM 80 User Guide Lexicon Matrix Bank Location Preset Type Program Bank 0 P0 Multi Effects P0 0.0 P0 Eko FlangeADJUST X-Fbk Flange Rvb Adjust FX MixFlange+RvbADJUST FX Mix Glide VerbADJUST FX Mix Modulation Effects P0 2.0 P0 3.5 contd Special Effects P0 3.6- P0 Program Bank 1 P1 Rhythmic Echo Delay Effects P1 0.0 P1Special Effects P0 3.6- P0 4.9 contd Rhythmic Echo and Delay Effects P1 0.0 P1 3.6 contd Pan-Eko Bpmadjust DarkKnob LatchedEkos Adjust EchoWidthPanEQ Bpmadjust Low Tone Tempo VerbADJUST Liveness Chase EchoADJUST ChaseRate BandEkoSweepADJUST Mstr FbkLFO EQ EchoADJUST LC Depth Panned DlysADJUST Mstr Fbk Ambience Effects P1 3.7 P1 Ambience Effects P1 3.7 P1 4.9 contd Program Bank 2 P2EQ Effects P2 0.0 P2 EQ Effects P2 0.0 P2 1.0 contd Spatial Effects P2 1.1 P2 Spatial Effects P2 1.1 P2 2.4 contd Gain Effects P2 2.5 P2 Gain Effects P2 2.5 P2 4.0 contd Chord WalkADJUST High Cut Pedal SwellADJUST FX MixRez Climber Adjust Tuning Mars BarsADJUST High Cut Resonant Chord Effects P2 4.1 P2 4.9 contd Program Bank 3 P3Reverb Effects P3 0.0 P3 Reverb Effects P3 0.0 P3 2.8 contd Drum GateADJUST Duration Plate4 Horns Adjust ImpactAlley SlapADJUST Pre Delay Slope Down Adjust Duration SweepVerbADJUST GldResp Dyna Vibrato Adjust GlideVibroVerbADJUST V-Depth EnveloVerbADJUST Rt HC0-40 Remix Effects P3 4.0 P3 4.9 contd Alphabetical Index of Presets PCM 80 User Guide Lexicon Selecting a Midi Channel Accessing Programs Registers Midi Operation Controlling PCM 80 Tempo Rate with Midi Clock Midi Tempo Control Using the PCM 80 as a Midi Clock SourcePCM 80 Tempo 0.2 Source set to Midi Control 3.7 Midi SysEx set to Receive On PCM 80sControl 3.4 Automation set to On Slaving two or more Midi Transmit Midi Adjust Program Change Messages Automation Reset All ControllersMidi Clock and Clock Commands SysEx Automation Dynamic Midi Displayed Name Description Yes Midi Implementation ChartFunction Transmitted Recognized Remarks OX Selectable PCM 80 User Guide Lexicon Common Midi Problems PCM 80 doesnt respond to SysEx commandsPCM 80 does not transmit SysEx Automation commands Midi Program Change numbers are off by No Digital Audio Output No Effects Output Restoring Factory Default Settings PCM 80 User Guide Lexicon Delay Audio Input ConnectorsAudio Output Connectors Impedance External Memory Card Connector Digital Audio Interface ConnectorsAudio Memory Configuration Base memory Footswitch Lexicon Inc Oak Park Bedford MA Telephone Fax