Lexicon PCM 80 Automation, Send Foot Pedal, Foot Sw 1, Foot Sw 2, ADJUST, Int Clock, SysEx, Dump

PCM 80 User Guide Lexicon

To load a specific Program Chain, without sending the PCM 80 a MIDI Program

Change message, use ADJUST to display the desired chain number.

MIDI Pgm Change
3.3 ✱Chain	3

3.4 Automation

This control is provided for communication with one or more additional PCM 80s. Select On to have values resulting from front panel operations sent out as SysEx messages. Press Load/✱ to select the ID (0-126or All) of the target PCM 80(s).

3.5 Send (Foot Pedal, Foot Sw 1, Foot Sw 2, ADJUST)

If Transmit is set to On these four controllers can transmit MIDI controller messages. Press Load/✱ to cycle through the controller selections. Use ADJUST to select the MIDI Controller message to transmit.

3.6 Int Clock

You can choose to have the PCM 80 transmit MIDI Clock at the current tempo rate by setting this control to On and Tempo mode Source (0.2) to Internal. If this control is set to Off, MIDI Clock will not be transmitted.

3.7 SysEx

This control is provided for communication with one or more additional PCM 80s or computer editor software. On (the default setting) allows SysEx messages to be received by the PCM 80. Press Load/✱ to select device ID (0-126).

3.8 Dump

Press Store to configure the PCM 80 to execute MIDI dumps of single effects, banks, maps, chains, or setups.

3.9 Dump Speed

Turn ADJUST to select dump speeds of Slow, Medium or Fast to achieve compatibility with the connected MIDI device.

2-14