Lexicon PCM 80 manual Off, Map, Chain

Basic Operation

Pgm+ and Pgm –, are available as subparameters in each location. Pgm+ will load the next higher effect in the current bank, map , or chain. Pgm – will load the next lower effect. You can select the following sources to activate Pgm+ and Pgm –:

Off Footswitch 1 Footswitch 2

•

•

•

MIDI Controller #119

On

Program Change messages 0—49 correspond to PCM 80 Effects 0.0 —4.9 in the current bank. Program Change messages 50—127 are ignored. The current bank can be changed with MIDI Bank Select Messages as follows:

0–3: Program Banks 0–3

4:Internal Register Bank

5–9: reserved

10–56:	Memory Card Banks. The number of banks available on a given
	card will vary with its size, as follows:
		Card Size	# Banks
		64	2
		256	11
		512	23
		1 Meg	47

Off

All Program Change and Bank select messages are ignored.

Map

Program Change 0-127 can be mapped to any PCM 80 effect in any internal or card bank. Two 128 element maps are stored internally, additional maps may be stored on RAM cards. Once you have selected Map, press Load/✱ to display:

MIDI Pgm Change

3.3✱MapSelect 0

Turn ADJUST to select the desired Program Change Map.

Chain

Any Program Change number can be selected to load any one of ten customized effect “chains". Additional chains can be stored on RAM cards. Once a chain is loaded, effects in the chain are accessed by the controller patched to Pgm + and Pgm – (program increment and program decrement). Once you have selected Chain, press Load/✱ to display:

MIDI Pgm Change

3.3✱Chain MIDI

Turn ADJUST to select the desired Program Chain. When set to MIDI, Program Chains will be loaded by MIDI Program Change messages according to the settings of Chain Pgm Assign in Row 6.

2-13