PCM 80 User Guide

Lexicon

 

Renaming the Effect Renaming an effect is straightforward. With the asterisk and the cursor posi- tioned as shown, turn ADJUST to select a new character. Press Up or Down to select a new type of character (upper case, lower case, numeric, symbolic, or blank). Simultaneously press Up and Down to clear all characters from the cursor to the end of the line. Turn SELECT to reposition the cursor over another character, and use ADJUST to change it. Continue in this manner until you have finished entering the new name. A maximum of 12 characters (including spaces) may be used.

Use ADJUST to select a new character. Turn

SELECT to move the cursor to another position.

Name:

Prime Blue

R 0.0

available

Renaming the ADJUST Knob Patch

Press Load/to select the ADJUST patch for renaming. The display will change to show the following:

The name of the ADJUST Knob patch will appear here. Use ADJUST to select a new character. Turn SELECT to move the cursor to another position.

ADJUST: Efx/Rvb X

R 0.0

available

Selecting a Bank and Press Load/to move the asterisk to the Register Bank ID.

Register Location

When the asterisk is positioned in front of

ADJUST:

Efx/Rvb X

the Bank ID, ADJUST or SELECT will scroll

R 0.0

available

 

 

through the available register banks.

 

 

Press Load/again to move the asterisk to the register matrix location.

When the asterisk is positioned in front of the register matrix location, ADJUST or SELECT will scroll through the available registers.

ADJUST:

Efx/Rvb X

R 0.0

available

Once you have made all the changes you want to an effect, and have selected a register location, press Store. If you press Store, the display will ask "Are you sure?" (Press STORE). If you don't want to save the effect as shown, press any button to cancel the operation. Press Store to complete the operation.

2-26

Page 44
Image 44
Lexicon PCM 80 manual Renaming the Adjust Knob Patch, Register Location