4026-0XX
Spot or Marks At Same Spot On Every Print
Note: Do not expose the photoconductor to light any longer than necessary when you remove the photoconductor unit from the printer.
| FRU | Action |
|
|
|
1 | Photoconduc- | Remove the photoconductor unit assembly and |
| tor Unit | check the photoconductor for voids, spots, or |
| Assembly | damage. |
|
|
|
2 | Fuser Paper | If black spots are observed approximately 70 |
| Separators | mm apart, check the fuser paper separators for |
|
| toner buildup. Clean or replace as necessary. |
|
|
|
Blank Page |
| |
|
|
|
| FRU | Action |
|
|
|
1 | Toner Car- | Remove the toner cartridge and gently shake |
| tridge | the assembly to evenly distribute the toner. |
|
|
|
2 | Printhead | Be sure the printhead actuator in the top cover |
|
| actuates the printhead switch in the printhead |
|
| assembly. |
|
|
|
3 | Printhead | Blank pages can be caused by a defective print- |
| Assembly | head assembly or engine board. If the toner car- |
|
| tridge is operating correctly, replace the |
|
| printhead assembly. If this does not correct the |
|
| problem, replace the engine board. |
|
|
|
All Black Page
Note: Incorrect laser exposure or incorrect charging of the photo- conductor causes an all black page.
| FRU | Action |
|
|
|
1 | Right Side | Check for a bent, broken, contaminated, or pit- |
| Frame Termi- | ted drum charge bias terminal or drum ground |
| nals | terminal located on the right side frame. |
|
| Replace as necessary. |
|
|
|