4026-0XX
| FRU | Action |
|
|
|
3 | Thermistor | If the fuser lamp comes on and a fuser failure |
|
| LED error code displays, be sure the thermistor |
|
| is contacting the hot roll and the thermistor |
|
| cable is firmly seated in connector CN2 on the |
|
| engine board. |
|
| Check for excessive toner buildup on the surface |
|
| of the thermistor. Clean or replace as necessary. |
|
| Turn the printer power off and disconnect the |
|
| thermistor cable from CN2 on the engine board. |
|
| Measure the resistance of the thermistor |
|
| between |
|
| should measure 250K ohms or less. If incorrect, |
|
| replace the thermistor and cable assembly. If |
|
| correct, replace the engine board. |
|
| Note: The thermistor assembly is fragile. Use |
|
| care when handling to avoid damage. |
|
|
|
4 | Fuser Lamp | If the fuser lamp does not come on and a fuser |
| Cable | failure LED error code displays, unplug the |
|
| printer power cord and check the continuity |
|
| between the fuser cable contacts in the lower |
|
| fuser cover. If incorrect, check the continuity of |
|
| the fuser lamp, thermal fuse and terminals. |
|
| Repair or replace as necessary. If correct, check |
|
| the continuity of the fuser lamp cable. If incor- |
|
| rect, replace the cable. If correct, replace the fol- |
|
| lowing FRUs one at a time in the order shown: |
|
| Engine Board |
|
| LVPS |
|
| If the lamp does not come on and the Error LED |
|
| is on solid, go to the “Fan Service Check” on |
|
| page |
|
|
|
5 | Fuser Ther- | Check the fuser thermostat if the fuser lamp |
| mostat (4026- | does not come on or if it comes on and does not |
| 06C and 06F) | go off. Unplug the printer power cord and check |
|
| the thermostat to be sure that it opens and |
|
| closes properly. Replace as necessary. |
|
|
|