4026-0XX
Cold Fuser Service Check
If all the Cold Fuser Service Check items are correct, go to the “Hot Fuser Service Check” on page
Note: Toner buildup on the fuser input guide, paper separator, hot roll and backup roll causes paper jams.
When toner is partially fused to the paper it is usually caused by low fuser temperature.
Avoid handling the lamp as much as possible as it is easily broken. Be careful not to touch the glass housing with bare hands as the skin contains acids that can weaken the glass.
When making checks and handling the fuser lamp make sure you allow enough time for the fuser lamp and associated parts to cool.
| FRU | Action |
|
|
|
1 | Line Voltage | The voltage to the printer must be within the fol- |
|
| lowing limits. |
|
| 100 V ac (90 V ac - 110 V ac) Japan |
|
| 120 V ac (108 V ac - 132 V ac) U.S. |
|
| 220/230 V ac (207 Vac - 253 V ac) W.T. |
|
|
|
2 | Fuser Lamp | Turn off the printer and wait a few minutes for |
|
| the fuser lamp to cool. Turn the machine on and |
|
| observe the lamp turning on during POST. You |
|
| can see the lamp through the left rear vents of |
|
| the top cover. If the lamp lights, be sure the cor- |
|
| rect voltage lamp is installed. The voltage rating |
|
| is stamped on one of the ceramic end pieces. |
|
|
|