Section TOC
Master TOC
TROUBLESHOOTING & REPAIR |
CAPACITOR REMOVAL AND REPLACEMENT (cont.)
Return to
Return to
PROCEDURE
NOTE: When replacing capacitors, remove the entire FET Heat Sink Assembly as a unit.
Remove and reassemble one side at a time, using the other side as a model to insure that all parts are reinstalled prop erly
1.Perform the Input Filter Capacitor Discharge
Procedure.
2.Remove the two 3/8” hex nuts from the top of the through bolts. The hex nuts are located on top of the fan shroud See Figure F.25.
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
FIGURE F.25 - REMOVING HEX NUTS
3.Turn the machine on it’s side as shown in Figure F.26. Slide the plastic insulators that go through the base to one side and pull out the through bolts, being careful to save all of the insulation and standoff materi- al. Set aside and save for reassembly.
