TOC
TOC
TROUBLESHOOTING & REPAIR |
SWITCH BOARD REPLACEMENT (cont.)
Return to Master
Return to Master TOC
Return to Master TOC
NOTE: If a test indicates that a Switch Board is defec- tive, unless their part number is
a.The part number of the Switch Boards is something other than
b.The machine was operating from 380 VAC or high- er when the failure occurred.
c.Burned areas are visible on the Switch Boards.
PROCEDURE
1.Perform the Input Filter Capacitor Discharge
Procedure.
2.Remove the Switch Board assembly from the machine as directed in the CAPACITOR
REPLACEMENT PROCEDURE.
3.Remove the four socket head screws that hold the Switch Board to the heat sink.
4.Remove the
5.Remove the Switch Board from the heat sink.
6.Clean the heat sink surfaces thoroughly to remove all the heat sink compound. During machine oper- ation, this compound helps conduct heat from the PC board to the heat sinks.
7.Apply a thin layer (.002”) of Dow 340 or Penetrox A13 Heat Sink Compound to the mounting sur- faces of the new PC board and to the Capacitor terminals. DO NOT allow the compound to enter the mounting screw holes because it can distort the torque values.
8.Prepare to mount the new PC board on the heat sink by first lining up the mounting holes. Then press the PC board into place.
9.Insert each of the four socket head screws into the mounting holes and thread finger tight. The threads are soft — be careful not to cross thread the screws.
10.Loosen the capacitor mounting bracket tightening screw. See Figure F.28.
11.Torque both sets of screws in 10
12.Tighten the capacitor mounting bracket mounting screw
13.Remount the assembly into the machine
14.Reconnect all the leads to the PC board. Double check that each lead is connected to the correct terminal. Failure to reconnect the leads correctly can result in machine damage when the power is applied.
15.Perform the Test After Repair of Switch Boards and/or Capacitors.
Return to Section TOC
Return to Master TOC
