Lincoln Electric SVM127-A service manual Figure A.2 Strain Relief Clamp

A-5 A-5

INSTALLATION

Return to Section TOC

Section TOC

FIGURE A.2 – STRAIN RELIEF CLAMP

CONTROL

CABLE

STRAIN

RELIEF

CLAMP

3.Remove the screws holding the cable clamp locat- ed near the rear of the wire reel base. Put the con- trol cable and the electrode cable under the clamp and install the screws. (On cables with more than one electrode cable, leave the junction between the cables and the single 4/0 stub behind the clamp so that only the single electrode lead is under the clamp.) Connect the electrode cable of the input cable assembly to the brass block on the hand crank.

4.Insert the connector on the conductor sheath of the extension assembly into the brass block of the hand crank assembly. Tighten the locking screw with a 3/16 hex allen wrench.

FIGURE A.3 – LN-9NE/SE INPUT CONTROL

CABLE AND ELECTRODE CABLE CONNECTIONS

Return to

ELECTRODE

WIRE DRIVE	POLARIZED	INPUT CABLE
UNIT	CONNECTOR	ASSEMBLY

TOC

Return to Master TOC

Return to Master TOC

TOC

CABLE

CONNECTING THE POWER INPUT CABLE ASSEMBLY TO THE LN-9NE or LN-9SE

The hand crank drive rolls will feed all the wires used on the extension. The rolls have been stenciled for identification.

EXTENSION	BRASS
	BLOCK
CABLE

HAND	WIRE REEL
CRANK	BASE

Return to Section

Return to Master

1.Position the extension assembly cable so that the amphenol plug with the threads on its O.D. can be attached to the amphenol end of the power input cable. Attach the opposite end to the wire drive unit. See Figure A.3.

2.Attach the amphenol extension assembly control cable (the one with threads on its O.D.) to the con- nector on the input cable assembly.

5.At the wire drive unit, connect the amphenol of the extension control cable to the receptacle on the back of the LN-9.

6.Remove the ingoing guide tube from the rear brass block and then plug the connector of the conductor sheath into the brass block. Tighten the locking screw with a 3/16" hex allen wrench. The guide tube removed is not used when the extension assembly is installed.

Return to Section TOC

Return to Master TOC

LN-9 Wire Feeder