![](/images/new-backgrounds/1301914/30191445x1.webp)
OPERATION
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
GENERAL DESCRIPTION
The
The wire feed speed and arc voltage can be "SET" before or during welding, and the "ACTUAL" values can be read during welding. Wire feed speed and arc voltage will be held virtually constant regardless of input voltage variation, feeding force, loading of the power source, ambient temperature changes or a volt- age drop in the electrode or ground circuit.
•Two drive rolls (driven) are used with calibrated idle roll pressure setting. Rolls are available for feeding
.030 thru 3/32" solid and .045 through .120" flux cored steel electrodes, as well as .035 through 1/16 aluminum wires.
•Four drive rolls (driven) are available and they work on a "quick release"mechanism for easy access to drive rolls and guide tubes. Drive roll kits are avail- able for the same electrode sizes as the
RECOMMENDED PROCESSES AND EQUIPMENT
When combined with the broad selection of quality welding equipment and accessories, the
Rated wire size range:
.030 through 3/32" solid wire electrode.
.045 through .120" Outershield® cored electrode.
.062 through 7/64" lnnershield® cored electrode.
Rated wire speed range:
50 through 600 inches per minute.
(1.27 through 15.2 meters per minute).
DC CONSTANT VOLTAGE POWER SOURCES
The following welding system power sources are avail- able for use with all
The Idealarc®
SAM power sources may also be used.
Return to Section TOC
Return to Master TOC