Lucent Technologies 20 manual

CellPipe™ 20 Series

User’s Guide

Part Number: 7820-0766-004

November, 2001

Contents

Main Lucent Technologies Customer Service CellPipe 20 Series Users Guide iii Customer Service Finding information and software Obtaining technical assistance Customer Service iv CellPipe 20 Series Users Guide Obtaining assistance through email or th e Internet Calling the technical assistance center (TAC) Contents Introduction .......................................................................... 1-1 Setup ..................................................................................... 2-1 Command-Line Interface ..................................................... 3-1 Configuring a 20 Series CellPipe ...................................... 4-1 Upgrading System Software.............................................. 5-1 Warranties and FCC Regulations ...................................... A-1 Introduction About this guide What is the CellPipe 20 Series Product Family? Lucent TURN-UP ! CellPipe 20 Series management Page Setup Verifying package contents Items you need for installation Connecting CellPipe 20 Series products Page Checking status lights Console setup Page Page Command-Line Interface Syntax of command-line interface Using the commands Viewing the main menu Displaying information about a command Returning to the main menu Displaying second-level commands Bridging commands Page Page Routing commands Page Command-Line Interface Routing commands 3-8 CellPipe 20 Series Users Guide Page Page Configuring a 20 Series CellPipe Auto-provisioning Configuring WAN interface SDSL commands and configurations Page ADSL commands and configurations Page Page Configuring LAN interface Configuring LAN interface in bridging mode Configuring LAN interface in routing mode Configuring the manage command Configuring the mode command Configuring the quick command The quick command in bridging mode The quick command in routing mode Configuring a 20 Series CellPipe Configuring the r1483 command CellPipe 20 Series Users Guide 4-11 Configuring the r1483 command You can configure the r1483 command for either bridging or routing mode. The r1483 command in bridging mode The following is a list of menus under the r1483 command in the bridging mode: The r1483 command in routing mode Configuring the dnsrelay command Configuring the ipoa command Configuring the pppoa command Configuring the pat command Page Upgrading System Software Preparing to upgrade Obtaining software ! Upgrading software Warranties and FCC Regulations Product warranty Warranty repair Out-of warranty repair FCC Part 15 Notice ! IC CS-03 Notice