Lucent Technologies 20 manual Configuring WAN interface, Sdsl commands and configurations

Configuring a 20 Series CellPipe

Configuring WAN interface

When you power up the unit, it is set to default (factory settings) and the console will display the following message:

Starting to download from remote server...

This means TURN-UP is enabled and is downloading the latest configuration information.

To disable the feature, interrupt the download and manually configure the system.

To re-enable the feature, you need to select the default command and reinstall the factory default configuration.

Configuring WAN interface

Currently the 20 Series units support SDSL and ADSL WAN interfaces.

SDSL commands and configurations

The following is a list of the menus available under the sdsl command:

auto - <Enable><Fast><Scan><Disable> autobaud rate function cell - <Enable><Disable> idle-cell header

dbit - configure the SDSL data bit as normal or reverse polarity default - set SDSL configuration back to factory setting enable - activate the last updated SDSL parameters

maxrate - configure the SDSL autobuad max rate rate - manually configure the SDSL line rate scramble - <Enable><Disable> payload scrambling smbit - configure sign/magnitude bit sequence

status - display the configuration and status of current SDSL setting

terminal - configure modem to COE or CPE mode

Select the auto command to set values for autobaud rate function.

>sdsl> auto <Enable><Fast><Scan><Disable>

(Scan Rate: 2320, 1744, 1536, 1152, 768, 384, 192)

4-2 CellPipe™ 20 Series User’s Guide