Configuring a 20 Series CellPipe
Configuring the pppoa command
Select the setqos command to set the class for quality of service.
>ipoa> setqos [<vpi>/]<vci> <ubrcbrvbr(nrt)>
Select the setrip command to set the PVC for RIP.
>ipoa> setrip [<vpi>/]<vci> <121&20>
Select the setwanip command to set up to eight PVCs, the WAN IP addresses for each PVC, and the gateway IP address.
>ipoa> setwanip [<vpi>/]<vci> <wanip[/<masknum>]> <gatewayip>
Select the show command to display the IPoA configuration.
> ipoa> show
IPoA setting:
FUNCTION VPI/VCI CLASS Wan IP/MaskNum GatewayIP RIP
Configuring the pppoa command
The following is a list of the menus available under the pppoa command:
adduser | - add user ID | and password |
chpass | - change user | password |
deluser | - delete user |
|
echo | - set echo interval time | |
setllc | - add LLC header on the packets | |
setqos | - set class |
|
setrip | - set RIP configuration | |
show | - show PPPoA configuration | |
Select the adduser command to set up a PVC, user ID, and select an authentication protocol for a user.
>pppoa> adduser [<vpi>/]<vci> <userid> [<chappap>]
Select the chpass command to change the password for the user of a pppoa connection.
>pppoa> chpass
Old Password:******
New Password:******
CellPipe™ 20 Series User’s Guide |
