Lucent Technologies 20 manual Using the commands, Viewing the main menu

Command-Line Interface

Using the commands

Using the commands

The CLI of the CellPipe 20 Series consists of two hierarchical levels. Some of the second-level commands display values or status of the selected commands from the main level.

Note: Access to the CLI is possible without a password. When user enables a password, the unit will time-out after 10 minutes if there is no activity on the unit. Re-entering password is necessary to resume activity.

The CellPipe 20 Series units display two sets of main menu commands based on the mode of operation—bridging or routing. The default list of main menu commands is for bridging. See “Bridging commands” on page 3-3. When selected for routing, the routing menus are displayed. See “Routing commands” on page 3-6.

Viewing the main menu

To view a list of the main menu commands, enter help at the >> prompt.

>>help

Displaying information about a command

To display information about a command, enter help followed by the name of the command.

For example, in the LAN menu, you can display information about the setip command as follows:

>lan> help setip

setip - setip <etherip[/<masknum>]> [subnet mask]

where etherip is the required information and [masknum] and [subnet mask] are optional information.

3-2 CellPipe™ 20 Series User’s Guide