Maintenance and Troubleshooting
Unipro 3.5
communications, and is always in receive mode unless responding to a question.
"X" Protocol
The "X" protocol software involves a Parameter Table, a Program Run Buffer, a Program Edit Buffer, and a Serial I/O Program Buffer. The UNIPRO can be written to using a "1TXparameternumber$da ta" format. This entry would place the data value in the proper location as determined by the parameter number. Any parameter can be read back from the UNIPRO using the following format "1Txparameternumber". Therefore, to write a value to the UNIPRO for a specific parameter use an "X" or to read a specific parameter from the UNIPRO, use an "x".
All of the parameters are listed below along with a short description. The numbers in the parenthesis are in Hexadecimal.*
Rev. 8.00
November 30, 1995
