Setup and Configuration
Unipro 3.5
programmed setpoint is at 0.80, the alarm will trigger at 0.90 and 0.70.)
DEV Alarm actuation uses DEVIATION control above or below the programmed setpoint. The + and - symbols determine if the deviation is allowed or if it is above (+) the programmed setpoint or below
FLT An input FAULT, or a program alarm is to be used as basis for the actuation.
The ALARM VALUE is ignored.
PRG An Internal program will actuate the alarm.
PO Alarm actuation is based on the PERCENT OUTPUT exceeding the limit in the ALARM VALUE .
PV PROCESS control mode. Alarm actuation is based on the PROCESS VARIABLE exceeding the limit in the