Maintenance and Troubleshooting
Unipro 3.5
b.The jumpers on the events board are improperly set. Should be configured for:
c.There is severe disruption of communication due to use of wrong cable, too long a cable run, routing of cable in
Message #93:
Indicates a limit statement has timed out. This must be interpreted in the particular situation, but if the limit time specified in the program was realistic, then a flaw in the system is indicated, or an instrumentation or operator error has occurred.
Message #94:
Not assigned.
Message #95:
Indicates an illegal ramp, the r OPCODE is not followed by the H OPCODE in the currently running program.
Message #96:
Indicates that a power failure has occurred and the UNIPRO started up again in the AUTO RESTART mode as determined by DIP Switch 5 on Bank 1.
Rev. 8.00
November 30, 1995
