■ Attaching the HDD to the HDD tray | 5. Connect the middle connector of the ATA LEAD to the HDD. |
♦When attaching one HDD:
1. Remove the top cover from the HDD tray.
• Remove the 2 screws and lift the top cover.
• Make sure that the lead between the PCB and the HDD is clamped. (A)
2.Remove the HDD holder on the right side of the HDD tray.
•Remove the 4 screws attached to the HDD holder to remove the HDD holder.
3.Attach the HDD holder on the side of the HDD.
•Use the supplied 4 screws to attach the HDD holder.
•Set the jumper of the HDD to “MASTER.” Refer to the instruction book of HDD for setting the jumper.
6.Unclamp the POWER LEAD and connect to the HDD.
•Clamp the POWER LEAD again after connecting to the HDD.
(B)
7.Check the wiring.
A:The lead between the PCB and the HDD is clamped.
B:The POWER LEAD which is connected to the HDD is clamped.
C:The POWER LEAD and the ATA LEAD that are not connected are clamped near their ends.
D:Push the POWER LEAD and the ATA LEAD between the middle connector and the outer connector into the space between the PCB and the HDD.
D
4. Attach the HDD holder to the HDD tray.
• Use the 4 screws that were removed in step 2.
A
B, C
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
16