Flowchart

Flowchart for connection and settings

Installation example:

Connect the terminals on the rear panel; and set the initial settings. Next, make an alarm recording using the timer function, using alarm list search, and playback the searched data.

Connections

• Connect the terminals on the rear panel.

See “ Connecting to CCTV camera, monitor, and sensor” on page 12.

• Connection for the alarm recording.

See “ Alarm recording connection” on page 13, and “ Rear view” on page 9.

• Connect the supplied wired remote control (R-400).

See “ Connecting the wired remote control R-400 (supplied)” on page 13.

Attaching the HDD

• Attach the HDD to this unit.

See “ Attaching and Removing the HDD to the DX-NT400E” on pages 14 to 17.

Setting up the unit

• Test the HDD attached to the unit.

See “ HDD SELF TEST” on pages 18 and 19.

• Set up the unit using <AUTO SET UP> menu.

See “ AUTO SET UP” on pages 20 and 21.

The unit boots-up.

Changing the initial menu settings

• Select the language.

See “ LANGUAGE SELECTION” on page 28.

• Set the present time and screen display.

See “<TIME DATE/DISPLAY SETTINGS>” on pages 34 and 35.

• Set the present time.

See “ TIME DATE ADJUST” on page 24.

• Set the display mode.

See “ DISPLAY MODE” on page 34.

Setting the HDD (hard disk drive) mode

• Set the repeat recording.

See “ HDD REPEAT REC MAIN/HDD REPEAT REC SUB” on page 47.

• Set the audio recording.

See “ AUDIO RECORDING” on page 48, and “ Continuous recording time table” on page 77.

• Set the remaining HDD capacity.

See “ REMAIN HDD” on page 50.

• Set the CALL OUT.

See “• HDD MAIN REMAIN/HDD SUB REMAIN” on page 50, and “• HDD MAIN FULL/HDD SUB FULL” on page 51.

• Set the buzzer.

See “ BUZZER” on pages 49 and 50.

Changing the multiplexer function

• Change the SPLIT4 screen setting.

See “ SPLIT4 SCREEN SETTING” on page 37.

• Change the sequence setting.

See “ SEQUENCE SETTING” on page 37.

Setting other various functions

• Change the display mode.

See “ CLOCK LOCATION SETTING” on page 34, and “ DUPLEX MODE DISPLAY” on page 35.

• Set the camera title/memo.

See “ CAMERA TITLE/MEMO SETTING”on pages 34 and 35, and “ CAMERA DISPLAY” on page 34.

• Set to output signals of the unit status.

See “ MODE OUT 1 to MODE OUT 5” on page 49.

••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••

6