8.Attach the top cover of the HDD tray.
•To attach the top cover, put the hooks of the top cover in the openings of the HDD tray.
•Use the 2 screws that were removed in step 1.
•Make sure that the lead is not caught in the top cover.
♦When attaching additional HDD:
1. Remove the top cover of the HDD tray.
•Remove the 2 screws and lift the top cover.
2.Remove the HDD holder on the left side of the HDD tray.
•Remove the 4 screws attached to the HDD holder to remove the HDD holder.
3.Follow the steps 3 and 4 in “♦ When attaching one HDD:” to attach the HDD holder on the side of the additional HDD, and then attach it to the HDD tray.
•Use the supplied 4 screws to attach the HDD holder.
•Set the jumper of the additional HDD to “SLAVE.” Refer to
the instruction book of HDD for setting the jumper.
•The leads should not be caught in the HDD holder or the HDD.
5.Connect the POWER LEAD to the additional HDD.
•Make sure that the POWER LEAD between the HDDs is clamped. (D)
6. Check the wiring.
A: The lead between the PCB and the HDD is clamped.
B, D: The POWER LEAD which is connected to the HDD is clamped.
C: The ATA LEAD is clamped.
E:Push the POWER LEAD and the ATA LEAD between the middle connector and the outer connector into the space between the PCB and the HDD.
E
A
B, C, D
ENGLISH
4.Connect the outer connector of the ATA LEAD to the additional HDD.
•Make sure that the ATA LEAD between the HDDs is clamped.
(C)
7.Attach the top cover of the HDD tray.
•To attach the top cover, put the hooks of the top cover in the openings of the HDD tray.
•Use the 2 screws that were removed in step 1.
•Make sure that the lead is not caught in the top cover.
Be sure to carry out HDD SELF TEST after attaching the HDD. (See the next page.)
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Attaching/Removing HDD
17