NEC IP8800/S6700, IP8800/S6600 manual 161, Set the system to restart Or stop, Specifying when

7. Restarting the System

As CPU memory dump is collected in Step 2, no parameter is selected as shown in figure above.

Step3

At last, select which system is restarted or stopped.

Figure 7-3: Selecting the System to Be Restarted or Stopped

Set the system to restart

or stop

		Specifying the		Specifying when
	Specifying the
	active system	standby system		operated in duplex
				or single system
Parameter to input	Active		Standby		None

As the standby system is restarted in Step 3, select "standby" as shown in figure above. Combining parameters selected in Step 1 to Step 3 results in "reload standby." Entering this command outputs the dump collection confirmation message as shown below.

1.Dump information extracted?(y/n):_

2.standby :old dump file(rmdump 06/21 18:32) delete OK? (y/n): _

3.Restart OK? (y/n): _

The output timing of above message corresponds to each number in flow chart shown below.

161