NEC NDA-30115-001 manual Data Link Maintenance

Message Formats Property Management System - Communication Interface

Note 3: In the case of messages that are almost identical, the FC will be marked with “**”. Also, differing FTC values will be marked with “*”. The final message is then constructed by simply inserting the desired FC value (and, if necessary, the desired FTC value).

All messages in this section have been previously defined in NEAX2400 IMS Hotel System PMS Interface Specification (except for one Maid Status message, which is so noted). The versions supported are Model 60 and Model 90; Model 120 messages are not supported. Any message that is intended to work with only one version is so designated; any message that is intended to work with both has no special designation.

The Feature Codes used are as follows:

•70 -- Data Link Maintenance

•11, 12, 51, 52 -- Maid Status

•13, 53 -- Message Waiting Lamp Control

•15 -- Restriction Control

•16 -- Check-In/Out (Model 60)

•56 -- Check-In/Out (Model 90)

•19 -- Wake Up/Group Announcement

•20 -- Room Move/Swap/Copy (Model 60)

•21, 61 -- Room Data Change

•17 -- Extension Report

•17 -- Room Recovery (Model 60)

•57 -- Room Recovery (Model 90)

•59 -- Direct Data Entry (Model 90)

•62 -- Extension Connection

Data Link Maintenance

These messages are used by the NEAX and the PMS to maintain the data link between them. The messages are as follows:

•70-0 -- Nop Test Normal Answer (Sent by NEAX)

•70-2 -- Nop Test Recover Answer (Sent by NEAX)

•70-3 -- Recovery Start Report (Sent by PMS)

•70-4 -- Recovery End Report (Sent by PMS)

•70-5 -- Data Link Release Request (Sent by PMS and NEAX)

•70-6 -- Data Link Release Confirmation. (Sent by PMS and NEAX)

•70-8 -- Extension Number Request (Sent by PMS)

•70-F -- Nop Test (Sent by PMS)

Page 32 NDA-30115 Revision 1.0