NETGEAR FVX538NA guide

Figure 5-1shows the WAN Mode setup screen for Auto-Rollover Mode using WAN port 1. It also shows the Protocol Bindings screen that displays if Load Balancing is selected. (When Load Balancing is selected, no WAN Failure Detection Method fields are selectable.) This setup is accomplished in “Configuring the WAN Mode (Required for Dual WAN)” on page 2-10.

Figure 5-1

The use of fully qualified domain names is:

•Mandatory when the WAN ports are in rollover mode (Figure 5-2 on page 5-3); also required for the VPN tunnels to fail over.

5-2	Virtual Private Networking

v1.0, August 2006