NETGEAR FWG114P v2 manual Advanced Configuration

Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P v2

These addresses are part of the IETF-designated private address range for use in private networks, and should be suitable in most applications. If your network has a requirement to use a different IP addressing scheme, you can make those changes in this menu.

The LAN IP parameters are:

•IP Address

This is the LAN IP address of the router.

•IP Subnet Mask

This is the LAN Subnet Mask of the router. Combined with the IP address, the IP Subnet Mask allows a device to know which other addresses are local to it, and which must be reached through a gateway or router.

•RIP Direction

RIP (Router Information Protocol) allows a router to exchange routing information with other routers. The RIP Direction selection controls how the router sends and receives RIP packets. Both is the default.

—When set to Both or Out Only, the router will broadcast its routing table periodically.

—When set to Both or In Only, it will incorporate the RIP information that it receives.

—When set to None, it will not send any RIP packets and will ignore any RIP packets received.

•RIP Version

This controls the format and the broadcasting method of the RIP packets that the router sends. (It recognizes both formats when receiving.) By default, this is set for RIP-1.

—RIP-1 is universally supported. RIP-1 is probably adequate for most networks, unless you have an unusual network setup.

—RIP-2 carries more information. RIP-2B uses subnet broadcasting.

Note: If you change the LAN IP address of the router while connected through the browser, you will be disconnected. You must then open a new connection to the new IP address and log in again.

10-6 Advanced Configuration

201-10301-02, May 2005