Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P v2

2.RESTART YOUR NETWORK IN THE CORRECT SEQUENCE

Warning: Failure to restart your network in the correct sequence could prevent you from connecting to the Internet.

a.First, turn on the broadband modem and wait 2 minutes.

b.Now, turn on your wireless firewall/print server.

c.Last, turn on your computer

Note

software usually logs you

the Internet, do not run that software, or cancel it if

it starts automatically

 

Broadband ProSafe 802.11g Wireless Firewall/Print Server

MODEL FWG114P

ACT

ACT

100

 

 

100

PWR TEST ALERT

 

1

2

3

4

LINK

LNK/ACT

 

 

LNK/ACT

P R I N TER

M O D EM

I N TER N ET

 

LO C A L

W LA N

Power

Test Internet Port

Local Port 4

Figure 3-4: Verify the connections to the firewall

d.Check the status lights and verify the following:

Power: The power light goes on when your turn the wireless firewall/print server on.

Test: The test light turns on, then goes off after less than a minute.

Local: A Local light on the router is lit. If no Local lights are lit, check that the Ethernet cable connecting the powered on computer to the router is securely attached at both ends.

Internet: The Internet light on the wireless firewall/print server is lit. If the Internet light is not lit, make sure the Ethernet cable is securely attached to the wireless firewall/print server Internet port and the powered on modem.

3-6

Connecting the FWG114P v2 to the Internet

201-10301-02, May 2005

Page 34
Image 34
NETGEAR FWG114P v2 manual It starts automatically, Verify the connections to the firewall