Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P v2

For Windows 95/98/Me, Use the Netgear Printer Port Driver

Follow these instructions to set up the Netgear Printer Port Drive on Windows 9x PCs.

Install the Netgear Printer Port Driver and configuration utility software.

a.Follow the instructions in the printed Installation Guide or this manual to install your FWG114P v2.

b.Connect your printer to the USB port on the back of the FWG114P v2.

c.Insert the Resource CD for the FWG114P v2 into the CD-ROM drive of a computer connected to the FWG114P v2.

The CD main page shown at the right will load.

d.Click the Print Server button.

Follow the instructions for running the setup utility.

e.Click Next to proceed through the Netgear Printer Port Installation Wizard steps.

Note: Windows 2000 or XP may require you to be logged on with administrator rights.

Warning: If you are installing the Netgear printer port driver on a Windows computer where an Epson printer had been installed, you must disable the Epson Spool Manager. Failure to disable Epson Spool Manager software will prevent the Netgear printer port driver from operating.

To disable the Epson Spool Manager, run the Epson Spool Manager, select Queue Setup from the menu, click Use Print Manager for this port, and click OK to exit.

FWG114P v2 Resource CD

Netgear Printer Port Installation Wizard

7-6

Print Server

201-10301-02, May 2005

Page 102
Image 102
NETGEAR FWG114P v2 manual For Windows 95/98/Me, Use the Netgear Printer Port Driver