NETGEAR R7000 user manual Specify the IP Addresses that the Router Assigns

Nighthawk AC1900 Smart WiFi Router Model R7000

-RIP-1. This format is universally supported. It is adequate for most networks, unless you have an unusual network setup.

-RIP-2. This format carries more information. Both RIP-2B and RIP-2M send the routing data in RIP-2 format. RIP-2B uses subnet broadcasting. RIP-2M uses multicasting.

8.Click the Apply button. Your changes are saved.

If you changed the LAN IP address of the router, you are disconnected when this change takes effect.

9.To reconnect, close your browser, relaunch it, and log in to the router

Specify the IP Addresses that the Router Assigns

By default, the router acts as a Dynamic Host Configuration Protocol (DHCP) server. The router assigns IP, DNS server, and default gateway addresses to all computers connected to the LAN. The assigned default gateway address is the LAN address of the router.

These addresses must be part of the same IP address subnet as the router’s LAN IP address. Using the default addressing scheme, define a range between 192.168.1.2 and 192.168.1.254, although you can save part of the range for devices with fixed addresses.

To specify the pool of IP addresses that the router assigns:

1.Launch an Internet browser from a computer or wireless device that is connected to the network.

2.Type http://www.routerlogin.net or http://www.routerlogin.com. A login screen displays.

3.Enter the router user name and password.

The user name is admin. The default password is password. The user name and password are case-sensitive.

The BASIC Home screen displays.

Specify Network Settings

99