TABLE OF FIGURES |
|
Figure 1- Secure rackmount ears to switch | 4 |
Figure 2- Secure switch to rack | 4 |
Figure 3- | 5 |
Figure 4- Connect the monitor | 5 |
Figure 5- Connect a PS/2 keyboard and mouse | 6 |
Figure 6- Connect a MAC keyboard/mouse | 6 |
Figure 7- Connect a SUN keyboard/mouse | 6 |
Figure 8- Connect a PS/2 CPU | 7 |
Figure 9- Connect a MAC CPU | 7 |
Figure 10- Connect a SUN CPU | 8 |
Figure 11- Use a | 8 |
Figure 12- Connect a | 9 |
Figure 13- Connect a PS/2 CPU to an | 9 |
Figure 14- | 10 |
Figure 15- Basic cascaded | 12 |
Figure 16- Installation of remote extension | 12 |
Figure 17- Video and Device connections identified with port numbers | 14 |
Figure 18- Administration Mode menu | 16 |
Figure 19- Switch Configuration Mode screen | 17 |
Figure 20- Switch configured as a master with one slave attached | 17 |
Figure 21- Administrator password change | 18 |
Figure 22- Command Mode menus | 20 |
Figure 23- Video and Device connections identified with port numbers | 21 |
Figure 24- Edit Mode | 22 |
Figure 25- Search Mode | 23 |
Figure 26- Maintenance Mode | 24 |
Figure 27- Command | 25 |
Figure 28- Touch Maintenance Mode | 26 |
Figure 29- Cursor Alignment menu | 26 |
Figure 30- RS232 dip switches | 27 |
Figure 31- Switch Configuration Mode screen | 28 |
Figure 32- Daisy chain configuration with | 29 |
Figure 33- RS232 connection with | 29 |
Figure 34- Pinout of | 30 |
Figure 35- Keyboard key layouts | 32 |
Figure 36- Location of jumper block | 33 |
Figure 37- Case screws must be removed | 34 |
Figure 38- Component layout inside case | 34 |
Figure 39- Clear access to the jumper block | 35 |
Figure 40- Remove standoff screws in unit with OSD | 35 |
Figure 41- Component layout in unit with OSD | 36 |
Figure 42- Clear access to jumper block | 36 |
Figure 43- Configure the jumper block | 37 |
Figure 44- Support present for touch screen monitor on | 37 |
iii | MAN064 Rev Date11/10/2005 |
