NTI NODEMUX SERIES UNIVERSAL KVM SWITCH
WiringSchematicofMatrix-Y-1cable
9DMale | 9DFemale | 9DMale | ||||||
(Unit#1) | (Source) | (Unit#2) | ||||||
2 |
|
|
|
|
|
|
| 3 |
|
|
|
|
|
|
| ||
3 |
|
|
| 3 |
|
| Notconnectedto | |
|
|
|
|
| ||||
5 |
|
|
| 5 |
|
|
| 5 sourceconnector |
|
|
|
|
|
| |||
2 2
7
8 Jumper
1
4Jumpers
6
Figure 34- Pinout of Matrix-Y-1 cable
Command Protocol
Terminal control commands supported by the NODEMUX are defined below.
Notes:
•All commands should be terminated with an <Enter> (ASCII 13) denoted by <CR>. When a command is sent, the entire string is echoed back to the terminal along with a response from the addressed unit as shown in the command definitions. Unit response will be sent within 500 msec after <CR>.
• All characters should be upper case, and all numbers below 10 should have a leading 0 (ex: 1 = 01).
•For units with one USER port (i.e. this NODEMUX switch), use 01 for the USER select.
RS - reset unit(s) to default
FORMAT: RS AA<CR>
RS = "reset unit" command followed by at least one space
| AA = unit address; if 00, all units on the bus will be reset and no response will be |
| returned |
RESPONSE: | *<CR> if command received and executed OK |
|
?<CR> if syntax or transmission error occurred
Note: The RS command does not change the switch configuration, it changes
CS - change single USER channel
FORMAT: CS AA,XX,YY<CR>
CS = "change single output" command followed by at least one space
AA = unit address
| XX = input/CPU to connect |
| YY = output/USER to change |
RESPONSE: | *<CR> (command received and executed OK) |
| |
| ?<CR> (syntax or transmission error occurred) |
30
