INSTRUCTIONS FOR USE
ENGLISH
MACHINE OPERATION
1.Avoid stopping for a long time with the machine in the same position and the brooms rotating: this could create unwanted marks on the floor.
Suction inlet and side broom shifting
2.When necessary, in working mode, shift the suction inlet and side brooms to the left or to the right by pressing the push- buttons (41 or 42, Fig. D) together with the safety
3rd broom shifting
3.When necessary, in working mode, shift the 3rd broom arm (23, Fig. G) to the left or to the right by pushing the joystick (46, Fig. D) to left or to the right.
NOTE
The 3rd broom shifting must be performed with the relevant switch (29, Fig. D) activated.
WARNING!
It is possible to shift to the left or to the right the 3rd broom arm (23, Fig. G) safely, only when the arm extension (22) is to the left or right end of stroke.
In this situation the arm shifting is limited by proper safety devices. Otherwise, an excessive shifting can damage the machine or affect its stability.
It is therefore advisable to bring always the 3rd broom arm extension (22, Fig. G) to the left or right end of stroke.
Bulky debris collection
4.To collect bulky debris, lift the front skirt (25, Fig. G) by pressing the
•Note that, while the skirt is lifted, the machine suction power decreases.
•To lower the front skirt (25, Fig. G), press the
5.If necessary, to collect bulky debris, it is also possible to remove the front skirt (25, Fig. G); remove it according to the following procedure:
•Lift the side brooms, then stop the machine and turn off the engine.
•Remove the clip (1, Fig. I) and disconnect the tie rod (2) from the skirt (3).
•Remove the skirt (3) by withdrawing it from the hinges (4).
•Turn on the machine and start working again.
•Install the skirt (3) in the reverse order of removal, after stopping the machine and turning off the engine.
NOTE
When the hopper is full, the machine cannot collect dust and debris anymore.
6.After each working cycle, and when the hopper (6, Fig. G) is full, it must be emptied. For the relevant procedure, see the next paragraph.
RS 1300
33015124(3)2008-02
23
