Nilfisk-Advance America RS 1300 Drive Power, Drive Pedal, CAB Heating, CAB Climate Control System

INSTRUCTIONS FOR USE

ENGLISH

Problem	Possible cause	Remedy
DRIVE POWER
The machine drive power is reduced	The drive pedal is faulty	Replace
	The by-pass is open	Check the by-pass screw tightening
	The drive system pump power decreases	Check the hydraulic system oil pressure on the
		drive system pump
	Worn drive motors	Replace
The machine has no drive power	Activated drive system pump deactivation	Deactivate
	screw (to facilitate machine towing)
	There are oil leaks from the hydraulic system	Repair
	Broken drive system pump	Replace
	Broken drive system motor	Replace
DRIVE PEDAL
The machine moves even if the drive pedal is	Misadjusted drive pedal	Adjust
released
CAB HEATING
There is no hot air	Broken hot water tap or pipes	Replace
	There are water leaks from the heater	Replace
	The switch is deactivated	Activate
	The fuse is blown	Replace
CAB CLIMATE CONTROL SYSTEM
There is no fresh air	The compressor does not turn because the	Adjust the tension/replace the belt
	drive belt is loosen/broken
	Deactivated thermostat	Activate
	There are gas leaks from the system	Repair the leak and integrate the gas
	The expansion valve is faulty	Replace
	The switch is deactivated	Activate
	The fuse is blown	Replace
	There is an open in the gas pressure switch	Replace
	The relay is burnt	Replace
DIESEL ENGINE
When turning the ignition key, the engine does	The drive pedal is pressed.	Do not press the drive pedal when starting the
not start		engine.

NOTE

For diesel engine complete troubleshooting, see the relevant Manual.

RS 1300

33015124(3)2008-02

49