Nortel Networks CVX 600 manual Replacing Modules and Filler Panels

CVX 600 Hardware Installation Guide

Replacing Modules and Filler Panels

Replacing Modules and Filler Panels

Introduction

This section provides instructions for replacing chassis components and hardware modules. It describes how to:

•Remove and install filler panels

•Replace the SCC-SM

•Replace the SCC-LTM or SCC-RLTM

•Replace other service modules (SMs)

•Replace DAC-LTMs and DAC-RLTMs

Note: You must wear an antistatic wrist strap when you remove or install these components and modules.

Removing and Installing Filler Panels

You must install filler panels in any empty slots at the front or rear of the

CVX 600 chassis. Filler panels ensure proper air circulation in the chassis, as well as assist in emissions compliance. If you need to install a card in an empty slot, you must first remove the filler panel.

3-4 296-1011-202 Rel. 5.0, Doc. Rev. 02.01