7
Control keypad | 53(86) |
7.3.2Parameter menu (M2)
Parameters are the way of conveying the commands of the user to the frequency converter. The parameter values can be edited by entering the Parameter Menu from the Main Menu when the location indication M2 is visible on the first line of the display. The value editing procedure is presented in Figure
Push the right arrow menu button once to move into the Parameter Group Menu (G#). Locate the parameter group desired by using the Browser buttons and push the HYPERLINK \l "menubuttonright" right arrow menu buttonagain to enter the group and its parameters. Use the Browser buttons to find the parameter (P#) to edit. From here it is possible to, proceed in two different ways: Pushing the right arrow menu button goes to the edit mode. As a sign of this, the parameter value starts to blink. The value can now be changed in two different ways.:
1Just set the new desired value with the Browser buttons and confirm the change with the Enter button. Consequently, the blinking stops and the new value is visible in the value field.
2Push the right arrow menu button once again. Now it is possible to be able to edit the value digit by digit. This editing manner may come in handy, when a relatively greater or smaller value than that on the display is desired. Confirm the change with the Enter button.
The value will not change unless the Enter button is pushed. Pressing the left arrow menu button returns to the previous menu.
Several parameters are locked, i.e. uneditable, when the drive is in RUN status. If an attempt is made to edit the value of such a parameter the text *Locked* will appear on the display. The frequency converter must be stopped in order to edit these parameters.
The parameters values can also be locked using the function in menu M6 (see Chapter
