Manuals
/
Brands
/
Household Appliance
/
Heating System
/
Oasis Concepts
/
Household Appliance
/
Heating System
Oasis Concepts
Diesel and AC Heating System for Recreational Vehicles and Yachts
Figure 5-2:Mounting a Spacesaver Fan, Figure 5-3:Installing a Relay for Additional Fan Amperage
1
38
80
80
Download
80 pages, 1.73 Mb
Section 5, Installing Fan Heaters
Figure
5-2:
Mounting a Spacesaver Fan
Figure
5-3:
Installing a Relay for Additional Fan Amperage
5-6
The Oasis™ Heating Module
Contents
OASIS™ Heating Module
Installation and
Operating Manual
Copyright © April
International Thermal Research
Website: http://www.itrheat.com
Right to Modify:
Table of Contents
Section 6, Wiring the Electrical System
Section 7, Plumbing the System
Section 8, Operating the Oasis™ Heating Module
Section 9, Installing Distribution Module, DM-12
(optional)
Warranty Information & Warranty Card
Page
Overview
Page
Page
Page
Figure 1-2:Oasis™ Heating and Distribution Module
Page
Page
Page
Mounting – Oasis™ Heating Module
!WARNING
!DANGER
Figure 2-1:Module Dimensions
! DANGER
Don’t
Figure 2-2:Module Mounting Brackets
Page
Installing the Exhaust System
Recommended Exhaust Outlet Locations
Recommendation for Installation
Page
What NOT to Do
Installation of the air-intakeadapter to the underside of the RV
Installation of the air-intakeadapter to the side of the RV
Figure 3-1:Installing the Exhaust System (Bottom Exhaust)
Figure 3-2:The Exhaust Hole Location & Mounting Template
Figure 3-3:The Exhaust Goose Neck configuration
Page
Installing the Fuel System
Recommendations for Installation
! CAUTION
Page
Page
Installing Fan Heaters – with “Distribution Module” Only
Features
Multiple Zone Heating
Accessories and Components Needed
air outlet plates
Page
Figure 5-2:Mounting a Spacesaver Fan
Figure 5-3:Installing a Relay for Additional Fan Amperage
Wiring the Electrical System
Page
Page
Page
Plumbing the
Page
Figure 7-1Heating Module
Page
If the Distribution Module is not utilized
Page
Operating the Oasis™ Heating Module
Available with the Optional Distribution Module:
Figure 8-1Oasis™ Heating Module
Figure 8-2Heating Module Main Control Panel
Activating the Burner (Primary Heat Source)
Activating the AC Immersion Element(s) (Secondary Heat
Source)
Page
Engine Heat Used for Domestic Water or Space Heating
Figure 8-3Remote Operating Panel
Page
Power Button
Bypass Button
•The bypass button is for authorized service personnel only
Reset Button
Power LED (Green)
Compressor, Fuel Pump, Combustion Fan, Igniter (Green)
Flame Out (Red)
Voltage Fault (Red)
Low Water (Red)
Figure 8-4:Zone Control Panel
Page
Burner Does Not Start Up
AC immersion elements do not activate
Burner Starts but Flame Faults
Burner Starts but Zone Faults
Installing the Distribution Module, DM12
Figure 9-1:Distribution Module, DM12
Figure 9-2:Distribution Module Zone Box
Figure 9-3:Distribution Module Fittings Location
Figure 9-4Domestic Hot Water System Plumbing
Figure 9-5Engine Heat / Pre-heatSystem Plumbing
Figure 9-6:Connecting to the OASIS Heating Module
Figure 9-7:Connecting two Heating loops
Figure 9-8:Initial fill up Oasis system
Page
Multi-PinConnectors
Cabin Fan leads
Page
Page
Page
Page
Warranty Information
NOTICE
Limited Warranty
Owner’s Responsibilities
Also not covered under warranty:
Customer Service Calls
Returns
Telephone / Email Service
IN CANADA:
IN THE UNITED STATES:
