Section 9, Installing the Distribution Module
•The Distribution Module is connected to the Distribution Module Zone Control Board through the electrical connections located at the bottom of the Zone Control Board box. The distance apart is dictated by the length of the 9 pin connector cord used.
9.4 Plumbing Installation
The plumbing installation should consider the following:
•The Distribution Module, see Figure
NOTICE
All fittings on the Oasis™ Distribution Module require two wrenches when tightening. One wrench must be placed on the module fitting and held in place to prevent this fitting from being overstressed. The other wrench can be used to tighten the matching half of the fitting onto it. Failure to follow this procedure will damage the Oasis™ Distribution Module, and the fittings.
International Thermal Research |