Section 8, Operating the Heating Module

Activating the Burner and AC immersion Element(s) Jointly

•Turn the burner switch ON and place the AC power switch on the Remote Operating Panel to either the one element or two element position. The Burner and AC Heat (green) LED’s will turn ON indicating the diesel burner and AC element(s) have been selected.

8.6Activating the Cabin Fan Heaters through the Thermostats

(Distribution Module Equipped Systems Only) (Burner or AC Heat or Engine Heat Source Available)

•Any thermostat connected to the Distribution Module’s Zone Control Board and calling for heat will cause the cabin fan controlled by that thermostat to be enabled. The ITR cabin fan has a built-in aquastat that prevents the cabin fan from blowing cold air. Once the room temperature has reached the temperature called for by the thermostat the cabin fan will turn off.

8.7Activating the Domestic Hot Water

NOTICE

(Oasis™ Heating Module and Distribution Module used in Tandem) (Burner or AC Heat On)

•As long as heat is available in the Oasis™ Heating Module, the Distribution Module (Optional) will respond to a call for domestic hot water. Ensure that a heat source has been selected (i.e. Burner, AC, Engine). The production of the domestic hot water is continuous on the Burner operation and limited when using AC or Engine.

The domestic water pump is not a part of, nor controlled by the Distribution Module or The Oasis™ Heating Module.

8.8Activating Engine Heat & Pre-heat

(Oasis™ Heating Module and Distribution Module used in Tandem) (Burner or AC Heat On)

Pre-heating the Engine

8-6

The Oasis™ Heating Module