Section 8, Operating the Heating Module
8.4Turning the Power to the Oasis™ Heating Module ON
•The Oasis™ Heating Module’s main Control Panel, Figure 8-2: Heating Module Main Control Panel, located on the front of the module contains three push buttons: ON/OFF power, Bypass, and Reset. The power switch must be pushed ON (power LED will turn ON) to turn the DC electrical power to the main control board and module ON and is required to be left ON during any period where heat is requested.
•When the Oasis™ Heating Module is shut down for any extended period or the season, it is recommended that the power switch be turned OFF.
Figure 8-2 Heating Module Main Control PanelDo not operate the Oasis™ Heating Module or Distribution Module (if installed) until a suitable water/anti-freeze solution is in the modules and all trapped air has been bled or removed.
Use only a non-toxic propylene glycol based coolant with additives generally recognized as safe ”GRAS” by the FDA in the Oasis™ Heating Module and Distribution Module.
