24xx
| FRU | Action | |
|
|
| |
1 | Paper Select | With the paper select lever in the cut sheet | |
| Sensor | position, do the following: | |
|
| • | Try to load a cut sheet with Load/Unload. |
|
|
| (This button should not work) |
|
| • | If paper loads, go to “Paper Select Sensor |
|
|
| Service Check” on page |
|
|
| |
2 | Paper Feed | If the paper does not feed, do the following: | |
|
| • Remove the ASF. | |
|
| • Be sure the base printer feeds paper | |
|
|
| correctly. |
|
| • | If the base printer does not feed paper |
|
|
| correctly, go to “Paper Feed Service |
|
|
| Check” on page |
|
|
| |
3 | Gear Train | Be sure the ASF drive gear on the inside right | |
|
| side frame of the printer rotates. | |
|
| Inspect the right side gear train for damage or | |
|
| debris. | |
|
| Remove the ASF right cover and ensure that | |
|
| all the gears are in good condition. | |
|
|
| |
4 | Combination Lock | Install the ASF and press FormFeed. | |
| Mechanism | If the picker drive shaft does not rotate, replace | |
|
| ||
|
| the combination lock mechanism. | |
|
|
| |
5 | Left and Right | If the ASF picker rollers rotate but a single | |
| Hoppers | sheet is not picked, inspect the springs and | |
|
| corner separators on the left and right hoppers. | |
|
| Be sure the paper load lever is in the correct | |
|
| position. | |
|
|
|
|
Diagnostic Information