24xx
8.Using a feeler gauge [1], slowly adjust the left gap adjust bushing [2] counterclockwise, until a gap of (within 0.33 and 0.37 mm) exists between the printhead [3] and the platen.
9.Move the printhead to the right edge of the rubber on the platen and using a feeler gauge [1], slowly adjust the right gap adjust bushing [2] clockwise, until a gap of (within 0.33 and 0.37 mm) exists between the printhead [3] and the platen.
10.After adjusting both left and right gap adjust bushings, push the printhead to the center of the platen and verify a gap of within (0.33 and 0.37 mm) exists between the printhead and the platen.
Repair Information
