24xx

Paper Present Sensor Service Check

 

FRU

Action

 

 

 

1

Paper Present

With no paper in the printer, the tractor in the

 

Sensor

push position, and the paper select lever set to

 

 

continuous forms, press Load/Unload; the

 

 

gear train should turn forward to load paper.

 

 

Activate the paper present sensor with a

 

 

screwdriver and press Load/Unload again; the

 

 

gear train should turn backward to park paper.

 

 

Measure the voltage between CN5-2 (paper

 

 

present signal) and CN5-3 (GND) on the logic

 

 

board. There should be 0 V dc when there is

 

 

paper in the printer, and +5 V dc when there is

 

 

no paper in the printer.

 

 

• Be sure the paper present sensor and its

 

 

actuator are properly installed and not

 

 

damaged.

 

 

• If the problem remains, replace the paper

 

 

present sensor.

 

 

 

2

Logic Board

If the ASF is being used, it is normal for the

 

 

paper out LED not to blink when there is no

 

 

paper in the printer. Do the following:

 

 

• Enter the Setup Menu.

 

 

• Be sure the ASF setting is off unless the

 

 

ASF is installed.

 

 

• If the paper present sensor is good and the

 

 

ASF setting is on, replace the logic board

 

 

and reset the “Bidirectional Print

 

 

Adjustment” on page 4-4.

 

 

 

2-22Service Manual

Page 40
Image 40
Oki 2400 manual Paper Present Sensor Service Check