OkiLAN 6200e Plus User’s Guide

Enable Port

This option allows you to enable or disable a port. If a port is disabled, it appears in the Network Print Server utility but does not appear in the Chooser. A disabled port cannot be configured. The only valid options for a disabled port are Status, Enable Port, Print Config, and Restore Defaults. A port should be disabled when no printer is attached.

Note: It is possible to disable all ports but this is not recommended. The EtherTalk protocol will still be active on the network. To disable the EtherTalk protocol, use a utility from one of the other proto- cols.

Reset Board

This option resets the print server.

Restore Defaults

This option automatically returns the EtherTalk inter- face to its factory defaults. All ports will be restored to factory defaults.

The following Network Print Server variables will restore to default:

Name: OKI <serial number> Port <port number> (for single port products, the port number is not shown)

Type 1 = LaserWriter

Type 2 = (None)

Zone = Default - (The default zone for the network segment is used)

Port Enabled = Yes

EtherTalk Support for Apple Macintosh

190

Page 190
Image 190
Oki 6200E manual Enable Port, Reset Board, Restore Defaults, Port Enabled = Yes