Job Programs
If you have a routine copy, fax or scan job that you perform on a regular basis, you can program the steps into your MFP and create a “short cut” allowing you to perform the steps at the touch of a button. You can create six short cuts using the Job Program function.
Creating a Job Program
To register a short cut:
1.Press the Job Program button on the control panel to prompt the Job Programs screen.
2.Select a job number you wish to associate to your program.
3.Select Yes to continue, or No to exit without saving.
4.Key in the steps you wish to program; for example if you wish to program a copy job that is
(a)Press the Copy button on the control panel.
(b)Press the Others button
(c)Press the DuplexCopy button
(d)Press the
(e)Press the Enter button
(f)Press the Scan Size button
(g)Press the A4(SEF) button
(h)Press the Enter button
(i)Press the Close button
(j)Using the numerical keypad, type in 20.
NOTE
Maximum of 60 steps per program; selecting or pressing a button counts as one step.
It is a good idea to write down the steps to be performed beforehand as every keystroke/button press is programmed.
5.Press the Job Programs button on the control panel.
6.Using the
7.Press the Enter button
NOTE
You cannot edit the steps within a program, if you wish to change them then you must reprogram the job number.
Operation > 110