NOTE: When a program is aborted, the instrument returns to the Controller Setpoint value. If a program is successfully completed, the Controller Setpoint is automatically set to the final setpoint value of the program. If it is desired to restore the initial Controller Setpoint value after the program is completed, this value should be used as the program Final Setpoint value.

1.6DISPLAY SEQUENCE - PROGRAM RUNNING

Proc ess Variable

value

Set point value

Read only

Active program setpoint value

NOTE: All displays are

Read Only whilst

program is running/held.

Final setpoint value for current segment

Time remaining in current segment

Cycles remaining for current program; for infinite cycling =

Omitted if No. Of Cycles = 1 (i.e. No cycling)

Current selected control mode:

= Automatic

= Manual

Omitted if Manual Control is disabled (see Section 2)

Event output/Alarm status:

Event output: E = active, blank = inactive

Alarm 1: 1 = active, blank = inactive Alarm 2: 2 = active, blank = inactive

Omitted if all three are inactive

Number of currently-running/held program (1 - 4)

O077-1

Volume II

1-3

Page 31
Image 31
Omega CN1166 manual Display Sequence Program Running, Read Only whilst Program is running/held