Onkyo TX-NR1007 instruction manual 127, Setting the Powered Zone 2/3, Not Act

Multi Zone—Continued

Setting the Powered Zone 2/3

If you’ve connected your Zone 2/3 speakers to the AV receiver, as explained in “Connecting Your Zone 2 Speakers Directly to the AV receiver” on page 124 or “Connecting Your Zone 3 Speakers Directly to the AV receiver” on page 126, you must set the “Powered Zone2” or “Powered Zone3” setting to “Act” (Acti- vated).

1	Press the [RECEIVER] button
	followed by the [SETUP] button.
	The main menu appears onscreen.
	If the main menu doesn’t appear, make
	sure the appropriate external input is
	selected on your TV.

4

5

Use the Up and Down [q]/[w] buttons to select “Powered Zone2” or “Powered Zone3”, and use the Left and Right [e]/[r] buttons to select:

Not Act:

ZONE 2/3 L/R speaker terminals not activated (Powered Zone 2/3 disabled).

Act:

ZONE 2/3 L/R speaker terminals activated (Powered Zone 2/3 enabled).

Press the [SETUP] button.

The setup menu closes.

2

3

Use the Up and Down [q]/[w] buttons to select “2. Speaker Setup”, and then press [ENTER].

The “Speaker Setup” menu appears.

2. Speaker Setup

1.Speaker Settings

2.Speaker Configuration

3.Speaker Distance

4.Level Calibration

5.Equalizer Settings

6.THX Audio Setup

Use the Up and Down [q]/[w] buttons to select “1. Speaker Settings”, and then press [ENTER].

The “Speaker Settings” menu appears.

2–1. Speaker Settings
Speaker Impedance	6ohms
Speakers Type(Front)	Normal
Powered Zone2	Not Act
Powered Zone3	Not Act

Notes:

•Powered Zone3 cannot be used if “Speakers Type(Front)” is set to “Bi-Amp” (see page 53).

•This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

127