Onkyo TX-NR1007 instruction manual Listening Angle, LFE Level, Analog Subwoofer, DAC Direct

Advanced Setup—Continued

Theater-Dimensional

Listening Angle	Wide: Select if the listening angle is greater than 30 degrees (default).
	Narrow: Select if the listening angle is less than 30 degrees.
With this setting, you can optimize the Theater-Dimen-		Front left speaker	Front right speaker
sional listening mode by specifying the angle of the front

left and right speakers relative to the listening position.

Listening angle: 30°

LFE Level

With these settings, you can set the level of the LFE (Low Frequency Effects) channel individually for Dolby Digital, DTS, multichannel PCM, Dolby TrueHD, DTS-HD Master Audio, and DSD sources.

If you find that low-frequency effects are too loud when using one of these sources, change the setting to –20 dB or

–QdB.

Dolby Digital*1, DTS*2, Multich PCM*3, Dolby TrueHD*4, DTS-HD Master Audio*5, DSD*6

The level can be set to –QdB, –20 dB, –10 dB, or 0 dB (default).

Notes:

*1 Sets the level of the LFE channel for Dolby Digital and Dolby Digital Plus sources.

*2 Sets the level of the LFE channel for DTS and DTS-HD High Resolution sources.

*3 Sets the level of the LFE channel for multichannel PCM sources. (Multichannel PCM is input via HDMI.) *4 Sets the level of the LFE channel for Dolby TrueHD sources.

*5 Sets the level of the LFE channel for DTS-HD Master Audio sources.

*6 Sets the level of the LFE channel for DSD (Super Audio CD) sources.

Direct

Analog

Subwoofer

This setting determines whether or not analog audio signals (bass signal) are output from subwoofer when the Pure Audio or Direct listening mode is selected.

Off: Analog audio signals (bass signal) are output (default).

On: Analog audio signals (bass signal) are output.

DSD

DAC Direct

This setting determines whether or not DSD (Super Audio CD) audio signals are passed through the DSP for A/V Sync, delay, etc., processing when the Pure Audio or Direct listening mode is selected.

Off: DSD signals are processed by the DSP (default).

On: DSD signals are not processed by the DSP.

Note:

Once you have selected “Yes”, only DAC Direct will be available for selection. “DSD Direct” will appear on the display.

98