Onkyo TX-NR1007 Speaker Setup, Advanced Setup—Continued, The main menu appears onscreen, Front*1

Advanced Setup—Continued

Speaker Setup

Some of the settings in this section are set automatically by Audyssey MultEQ® XT Room Correction and Speaker Setup (see page 56).

Here you can check the settings made by Audyssey MultEQ® XT Room Correction and Speaker Setup, or set them manually, which is useful if you change one of the connected speakers after using Audyssey MultEQ® XT Room Cor- rection and Speaker Setup.

Note:

The Speaker Setup cannot be carried out while headphones are connected to the AV receiver.

1	Press the [RECEIVER] button followed by
	the [SETUP] button.
	The main menu appears onscreen.
	If the main menu doesn’t appear, make sure the
	appropriate external input is selected on your TV.
2	Use the Up and Down [q]/[w] buttons to
	select “2. Speaker Setup”, and then press
	[ENTER].
3	Use the Up and Down [q]/[w] buttons to
	select the submenu, and then press

[ENTER].

4	Use the Up and Down [q]/[w] buttons to
	select setting, and then use the Left and
	Right [e]/[r] buttons to set them.
5	When you’ve finished, press the [SETUP]
	button.

The setup menu closes.

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

Speaker Settings

See “Speaker Settings” on page 53.

Speaker Configuration

With these settings, you can specify which speakers are connected and a crossover frequency for each speaker. The following crossover frequencies can be specified: “Full Band”, “40Hz”, “50Hz”, “60Hz”, “70Hz”, “80Hz(THX)”, “90Hz”, “100Hz”, “120Hz”, “150Hz”, or “200Hz”. Specify “Full Band” for speakers that can output low frequency bass sounds adequately, for example, speakers with a good sized woofer. For smaller speakers, specify a crossover frequency. Sounds below the crossover frequency will be output by the subwoofer instead of the speaker. Refer to your speaker’s manuals to determine the optimum crossover frequencies.

If you set up your speakers using Audyssey MultEQ® XT Room Correction and Speaker Setup, please make sure manually that any THX speakers are set to “80Hz(THX)” crossover.

Subwoofer	1ch: Audio signal is outputted from SW1 jack only.
	2ch: Audio signal is outputted from SW1 and SW2 jacks (default).
	No: Select if no subwoofer is connected.
Front*1	Full Band, 40Hz, 50Hz, 60Hz, 70Hz, 80Hz(THX) (default), 90Hz, 100Hz, 120Hz,
	150Hz, 200Hz
Center*2	Full Band, 40Hz, 50Hz, 60Hz, 70Hz, 80Hz(THX), 90Hz, 100Hz, 120Hz, 150Hz,
Surround*2	200Hz
	None: Select if no speaker is connected.
Front Wide*2*3*5
Front High*2*3*9
Surr Back*3*4*6

90