Onkyo TX-NR1007 instruction manual Troubleshooting—Continued, Recording Can’t record

Troubleshooting—Continued

Recording

Can’t record

•On your recorder, make sure the correct input is selected.

•To prevent signal loops and damage to the AV receiver, input signals are not fed through to outputs with the same name (e.g., TAPE IN to TAPE OUT or VCR/DVR IN to VCR/DVR OUT).

•When the Pure Audio listening mode is selected, recording is not possible because no video signals are output. Select another listening mode.

Zone 2/3

There’s no sound

•Only components connected to analog inputs can be played in Zone 2/3.

Music Server and Internet Radio

Can’t access the server or Internet radio

•Check the network connection between the AV receiver and your router or switch.

•Make sure that your modem and router are properly connected, and make sure they are both turned on.

•Make sure the server is up and running and compatible with the AV receiver (page 120).

•Check the “Network Settings”(page 121).

Playback stops while listening to music files on the server

•Make sure your server is compatible with the AV receiver (page 120).

•If you download or copy large files on your computer, playback may be interrupted. Try closing any unused programs, use a more powerful computer, or use a dedicated server.

•If the server is serving large music files to several net- worked devices simultaneously, the network may become overloaded and playback may be interrupted. Reduce the number of playback devices on the net- work, upgrade your network, or use a switch instead of a hub.

Can’t connect to the AV receiver from a Web browser

•If you’re using DHCP, your router may not always allocate the same IP address to the AV receiver, so if you find that you can’t connect to a server or Internet radio station, recheck the AV receiver’s IP address on Network screen.

•Check the Network settings (page 121).

Others

The sound changes when I connect my headphones

•When a pair of headphones is connected, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono, Direct, Pure Audio or DTS Surround Sensa- tion.

The speaker distance cannot be set as required

•In some cases, corrected values suitable for home the- ater use may be set automatically.

The display doesn’t work

•The display is turned off when the Pure Audio listen- ing mode is selected.

How do I change the language of a multiplex source

•Use the “Multiplex” setting on the “Audio Adjust” menu to select “Main” or “Sub” (page 95).

The u functions don’t work

•To use u, you must make an uconnection and an analog audio connection (RCA) between the compo- nent and AV receiver, even if they are connected digi- tally (page 42).

•While Zone 2 or Zone 3 is selected, the ufunctions don’t work.

The functions Auto Power On/Standby and Direct Change don’t work for components connected via u

•These functions don’t work when Zone 2/3 is turned on.

When performing “Audyssey MultEQ® XT Room Correction and Speaker Setup”, the measurement fails showing the message “Ambient noise is too high.”.

•This can be caused by any malfunction in your speaker unit. Check if the unit produces normal sounds.

151