Onkyo TX-NR1007 instruction manual Channel Sources 3/3, Theater Dimensional DTS Surround Sensation

Using the Listening Modes—Continued

5.1 channel Sources (3/3)

✔: Available Listening Modes

Speaker layout

LH

RH

LH

RH

LH

RH

*1 LH *2

*1 RH *2

LW

FL

C

FR

RW

LW

FL

C

FR

RW

LW

FL

C

FR

RW

LW

FL

C

FR

RW

*1

*1

Listening Mode

Button

*2

*2

SW

SW

SW

SW

SW

SW

SW

SW

SL

SR

SL

SR

SL

SR

SL

SR

*2

*2

SBL

SBR

SBL

SBR

SBL

SBR

SBL

SBR

T-D (Theater-

✔

✔

✔

✔

Dimensional)

DTS Surround

✔

✔

✔

✔

Sensation

Notes:

*1 For 7ch output, output can be switched between Front high or Front wide speakers by pressing the [SP LAYOUT] button (depending on the “Speaker Configuration” setting (see page 90)).

*2 For 9ch output, output can be switched between the combination of Surround back and Front high, or Surround back and Front wide speakers by pressing the [SP LAYOUT] button.

*3 AV receiver can input the DSD signal from HDMI IN. Setting the output setting on the player side to PCM might obtain a better sound according to the player. In that case, set the output setting on the player side to PCM.

*4 This listening mode can be selected only when all the following conditions are satisfied: a. Center speaker is connected to the AV receiver.

b. Either of Front High speakers or Front Wide speakers is connected to the AV receiver.

*5 This listening mode is not available while you are using Zone 2 (“Not Available” will appear on the display). If you turn Zone 2 on during the Pure Audio listening mode, the listening mode will change to Direct.

*6 Depending on the input source, DTS is used.

•Available sampling rate for PCM input signal is 32/44.1/48/88.2/96/176.4/192kHz.

•The listening modes cannot be selected with some source formats.

82